3-Input In-wall HDBaseT Transmitter (2-gang UK) – SW-130-TX-UK

3 inputs and powerful HDBaseT transmission result is this powerful switching transmitter, perfect for corporate meeting and classroom environments. Automatic or manual switching of 2 HDMI’s or USB-C and CEC power triggering via HDBaseT mean a simple user experience when it matters most. Further functionality allows USB devices to be routed back to the source via USB host (or natively via USB-C) and charging for the connected USB-C device.

Specifications
TRANSMISSION
Transmission Encoding: HDBaseT Class C | PAM16 Encoding

End to End Latency: 10µs

Max. Transmission Bit Rate: 10.2Gbps

VIDEO
HDMI: (v2.0b) TMDS | 340MHz Maximum

Inputs: 2x HDMI In: 19-pin type A1x USB-C In: USB 3.1c Audio/Video (4.5Gbps)

Outputs: 1x HDBT out: 8-pin RJ45

Max Pixel Clock: HDMI & HDBaseT: 340MHz

Video Resolution (Max):
1920x1080p @60Hz
2560x1440p @60Hz
3840x2160p @30Hz 8bit 4:4:4
3840x2160p @30Hz 10bit 4:2:0 HDR
3840x2160p @30Hz 12bit 4:2:2 HDR
Note: WyreStorm recommends the use of shielded category cable to minimize signal noise and interference.

Supported Standards: DCI | RGB | HDR | HDR10 | Dolby Vision up to 30Hz | HLG | BT.2020 | BT.2100

AUDIO
Inputs:
1x Audio In: 3.5mm (1/8in) TRS Stereo
2ch audio over HDBaseT | 1-way to RX

Audio Formats: 2ch PCM | Multichannel up to DTS-X and Dolby Atmos

Maximum Sampling Rate: 192KHz

Maximum Audio Channels: 32

Audio Return Channel (ARC): Not Supported

COMMUNICATION & CONTROL
USB Host (HDMI Inputs): 1x Type B host | Maximum data throughput: 190Mbps

HDMI: Alt-mode Supported | A/V and USB data from RX

USB 3.1c: HDMI | HDCP 2.2 | EDID | CEC | 2ch audio | USB

RS-232: 1x RS-232: 4-pin Phoenix | Shared with 12v DC input
Compatible with WyreStorm TS-280 touchscreen via 4-pin phoenix port (only when using PoH)

HDCP: Pass-Through, 2.3 Supported

EDID: Pass-Through, from RX

Consumer Electronics Control (CEC): One-way display trigger to RX

Auto Low Latency Mode (ALLM): Supported

Variable Refresh Rate (VRR): Supported

POWER
Power Supply: 12V DC 1A (not included)

Max Power Consumption: 7.8W

Power-over-HDBaseT (PoH): Supported, 1-way from RX

Local Power Supply Input: 4-pin Phoenix