C2210 Series

The ION C2210 is a media converter module that provides an interface between 10/100Base-TX ports and 100Base-FX ports, allowing users to integrate fiber optic cabling into 10/100 copper environments. Operating at Layer 2, the data link layer, this converter not only converts copper to fiber, it also provides rate conversion allowing legacy 10Base-T copper devices to connect to 100Base-FX fiber. The ION C2210 is a manageable device when installed in a managed ION chassis.

Specifications
Data Rate: 10 Mbps; 100 Mbps Layer 2

MAC Address Table: 1K

Frame Buffer Memory: 512 Kbits

Max Frame Size: 2048 bytes

Switch:
SW1: Auto-Negotiation (UP = enabled)
SW2: Forced 100 Mbps/10 Mbps with Auto-Neg. off (UP = 100 Mbps)
SW3: Forced Full/Half-Duplex with Auto-Neg. off (UP = Full)
SW4: Full/Half-Duplex on fiber port (UP = Full)
SW5: Auto-MDI/MDIX on UTP (UP = enabled)
SW6: Link Pass Through (UP = enabled)

Internal Jumper: Auto-MDI/MDIX: Enable/Disable

Jumper:
Hardware: Mode of operation is determined by the settings on the 4-position switch
Software: Mode of operation is determined by the most recently saved on-board microprocessor settings

Status LEDs:
FD (Fiber Duplex): ON= Full-duplex on fiber
LACT (Fiber Link/Activity): ON = Fiber Link
PWR (Power): ON=Connection to powered backplane
(TP. Duplex/Link): Yellow = Half duplex, Green = Full-Duplex
(TP. Speed): Yellow = 10Mbps, Green = 100 Mbps

Dimensions:
Width: 0.86” [22 mm]
Depth: 6.5” [165 mm]
Height: 3.4”[86 mm]

Power Consumption: 2.5 Watts, 200 mA @ 13.9 VDC

Environment:
Operating: 0°C to 50°C
Humidity: 5% to 95% (non-condensing)
Altitude: 0 – 10,000 ft.

Weight: 1 lb. [0.45 kg]

MTBF:
Greater than 250,000 hours (MIL-HDBK-217F)
Greater than 667,500 hours (Bellcore)